CIRCUIT TESTING TOOL
MY 74 CB750 IS BLOWING FUSES DUE TO TOO MUCH LOAD ACROSS THE MAIN 15 AMP FUSE. TO MAKE THIS TOOL YOU NEED 2 ALLIGATOR CLIPS, HEAVY DUTY ATC BLADE TYPE FUSE HOLDER AND A APPROPRIATE AMP CIRCUIT BREAKER. I SOLDERED THE HOLDER WIRES INTO THE CLIPS. REMOVE THE FUSE AND CONNECT AN ALLIGATOR CLIP TO EACH TERMINAL. USING A CIRCUIT BREAKER SAVES HAVING TO BUY FUSES WHILE TRACKING DOWN THE OVERLOAD PROBLEM.
USE 2 DIFFERENT SIZES OF HEAT SHRINKABLE TUBING TO INSULATE THE CLIPS. USE A SMALL ONE WHERE THE WIRE IS SOLDERED IN AND A LARGE ONE OVER THE JAWS OF THE CLIP. IF YOU HAVE LIQUID RUBBER IN A CAN YOU CAN DIP THE CLIP IN THAT ABOUT 1/4 INCH BEYOND THE CLIP ONTO THE WIRE.  ON MY BIKES THE FUSE BLOCK IS NEXT TO THE FRAME SO IT IS CRUCIAL THAT A SHORT SITUATION IS ELIMINATED TO PREVENT A BURNED UP HARNESS OR FIRE.